PT Logic
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Logic 9 No waveform for audio in Arrange

Discussion in 'Logic 9' started by honeychrome, May 8, 2013.

  1. honeychrome

    honeychrome New Member

    Suddenly Logic isn't drawing the waveforms for audio tracks in the Arrange window. Actually I can see it drawing when recording, but when I stop the waveform disappears (but I can see it in the sample edit window). Suspect maybe I inadvertently turned something off, but can't figure out what it is. Suggestions?
  3. synthhead01

    synthhead01 New Member

    If the signal is low enough it may not appear on the regions in the arrange. You can amplify the waveform display if you need to, similar to Pro Tools. Click the waveform button near the horizontal zoom/scrollbar for the Arrange Window. You can also click-hold to adjust (drag) between max and minimum displays.
  4. honeychrome

    honeychrome New Member

    No, its not that.... The waveforms for older audio tracks are there, just not for any new tracks I record...
  5. Eli

    Eli Senior member

    Are you using take folders?
  6. Roy_L

    Roy_L New Member

    I saw this once, and it turned out that somehow the Record Delay setting in Audio Preferences had been set outrageously high.

Share This Page