PT Logic
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Logic 9 Using 2 control surfaces but not at the same time...

Discussion in 'Logic 9' started by toko, Apr 16, 2014.

  1. toko

    toko New Member


    I have a Behringer BCF2000 which worked fine in Logic Pro 9.

    I recently bought a Behringer X32 compact which can act as a DAW controller, too.

    After installing it as a control surface in Logic, I can control the first 8 channels with the X32 and the next bank with the BCF2000 or vice versa (depending on which one is shown first in the control surfaces list).

    Is there any way I can disable one of the two when I want to use the other?
    I use the X32 in our rehearsal room and the BCF2000 at home, so there's only one of them active at a time.
    I don't really want to delete and re-install one of them each and every time…

    Thank you very much for your help!


  3. toko

    toko New Member

    I guess, I have just figured it out by using
    - control surface groups (now I have two instead of one)
    - assigning the ports of the X32 for it instead of "all" (this was set up correctly for the BCF2000 already).

Share This Page