1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Volume jumps in cycle mode?

Discussion in 'Music Creation' started by dsw67, Apr 27, 2011.

  1. dsw67

    dsw67 Member


    While looping a midi bass part in cycle mode I noticed it was too loud in the mix so I lowered the volume. Trouble is, when it starts to cycle again the volume jumps back to it's original location. Why does it do that, and how can I fix it?


  3. Eli

    Eli Senior member

    It's likely because there is automation there. Each time it goes around to the place where the automation node or event is, it springs back to that value. The solution is to write the volume change in that you want as automation.

Share This Page