Discussion in 'Logic 9' started by Halvor, Jan 20, 2011.
0 or 1?
0 is hard.
If you set it to a high ratio, you can actually see the sharp angle of the hard knee in the graphic display. You see it softening or getting a curve as you move the slider towards 1.
BTW, while on the subject of Logic's compressor, don't overlook the extra goodies hidden by the little triangle at the bottom left of the GUI.
0 is hard, and the more you move the value to 1, the softer it gets. The Plugin UI shows this very clearly.
<Edit> Pete was faster
Set a high ratio, maybe change the model, then you see the knee in the display. 0 is hard, 1 is soft.
Edit: Pete and Mark were faster ;-)
Separate names with a comma.