2882 to Drawmer Mx 30 and back to 2882

Liedschatten

Logician
Hi there!

I recently contacted the fantastic Metric Halo Support to answer my questions but I still don't get my "problem" solved properly. Maybe you can help:

I would like to use a Drawmer Mx 30 as an external gate and compressor.

What I did so far:

2882 outputs 5/6 connected to the inputs of the drawmer.
Drawmer Outputs connected to Analog 1 & 2 of the 2882 to record the processed material which comes out of the drawmer.

Now I want to:
1. Listen to the material before the drawmer and after and I tried to route this in the monitor controller. But always there wasn't either a signal at all or I had a big feedback coming out of my headphones or monitors.
2. Integrating this into Logic Studio

Can anybody help me how to implement a drawmer or any other outboard?

Thanks in advance!!!!!
 

Stevelalonde

Logician
To integrate with logic, Your answer is in the plugin utility>I/o

There you can create sends on every track to the MIO console. You then need to setup your console to send back the audio to logic.

E.g. Create a new track in MIO console, put daw3 as input and fw3 as direct output. (after the plugins) you can now insert a MIO strip and use the character. You put an I/o plugin on your guitar track in logic and you're good to go!

For more information see p134 of the mh user guide
http://metric-halo.com/media/MobileIOUsersGuide.pdf
Or this SOS article
http://www.soundonsound.com/sos/dec07/articles/logictech_1207.htm

To send to your drawer, you'll need two strips in MIO console. One with daw 5/6 as input and analogue 5/6 as direct output. Another with say analogue 5/6 as input and fw5/6 as direct output. You can also create sends to your headphones mix to monitor what's happening.
 
Top