(bottom of page)
paulnajar
Logician
Hoping someone can either confirm or deny this small issue I've just discovered.
Using a Mackie C4 Control Surface in it's Function Mode, V-Pot 25 (bottom left) is assigned to waveform zoom, which I use a bit. The behaviour I am getting is that this control does NOT work when on screen displays the Logic workspace.
When I opened up the Controller Assignments Window to check it's assignment the same v-pot function works perfectly. Close the Controller Assignment window and the function stops working again.
Hopefully I'm not the only guy in the universe using a C4 so I can get some verification on this.
Kind regards
Using a Mackie C4 Control Surface in it's Function Mode, V-Pot 25 (bottom left) is assigned to waveform zoom, which I use a bit. The behaviour I am getting is that this control does NOT work when on screen displays the Logic workspace.
When I opened up the Controller Assignments Window to check it's assignment the same v-pot function works perfectly. Close the Controller Assignment window and the function stops working again.
Hopefully I'm not the only guy in the universe using a C4 so I can get some verification on this.
Kind regards