Logic Pro Reverb Sends Not Working in Logic, Why?

Martin John Butler

Martin John Butler

Logician
I just started a new project. Set it up from a template I've used before. I did some recording. When I went to listen back, the reverb sends weren't working. I looked around, I'd turned of Low Latency, so I re-instantiated the reverbs, and still, nothing.

Anyone have any ideas why this is happening?



Screen Shot 2017-10-13 at 1.36.32 PM.png
 
Sort by date Sort by votes
Does this also happen without Solo? I have problems with Solo, occasionally.

Or – maybe your old template does not work properly in your current Logic version. Open that template again and try a simple send. If it does not work, try with a new project, without a template. If this works, you have to rebuild your template(s) with the current Logic version.
 
Upvote 0
Good thinking Peter, thanks. It happens whether I solo or not. I tried a new project, imported tracks, same thing. So I then tried creating different number sends in the original project, 5,6,7,8, and that worked.

I then tried sends 1,2,3, and then they worked. I think you're right, the template could be the issue. It took a while creating that one, but I'll do a new one. I appreciate the swift reply. Best regards.
 
Upvote 0
From your screenshot, it looks like your Reverbs are not solo-safed, so they get muted when you solo the track. That doesn't explain why they're not working if you are not in solo mode, however.
 
Upvote 0
I went to a project I began a few months ago to track a new vocal today. I finished the vocal, all was normal. I went to bounce, and the sends had stopped working. So now, all the buss reverbs aren't working.

Any idea what might be causing this?
 
Upvote 0
I got it. Somehow I had the reverbs on audio tracks, and not Aux tracks. They looked like typical bus channels, but I removed those channels, adde Aux channels, and now it's fine. I have no idea how I made that happen.
 
Upvote 0
Back
Top