Logic Pro 9 Using 2 control surfaces but not at the same time...

[toko]

Hi.

I have a Behringer BCF2000 which worked fine in Logic Pro 9.

I recently bought a Behringer X32 compact which can act as a DAW controller, too.

After installing it as a control surface in Logic, I can control the first 8 channels with the X32 and the next bank with the BCF2000 or vice versa (depending on which one is shown first in the control surfaces list).

Is there any way I can disable one of the two when I want to use the other?
I use the X32 in our rehearsal room and the BCF2000 at home, so there's only one of them active at a time.
I don't really want to delete and re-install one of them each and every time...

Thank you very much for your help!

Regards

toko

 

[toko]

I guess, I have just figured it out by using
- control surface groups (now I have two instead of one)
- assigning the ports of the X32 for it instead of "all" (this was set up correctly for the BCF2000 already).